Part of the data ring
CookClock
Smoked Pork Butt · 275°F smoker

Smoked Pork Butt
at 275°F

The answer

8 hr – 10 hrat 275°F

Plan on 60 to 75 minutes per pound in a 275°F smoker. A 8 lb smoked pork butt lands around 8 hr – 10 hr. Done is 145°F on a food thermometer, plus a 45-minute rest — never the clock alone.

SOURCE·USDA FSIS safe minimum internal temperatures·275°F planning range derived·REVIEWED JUL 2026

Time (8 lb)8 hr – 10 hrat 275°F
Per pound60–75 minplanning range
Done at145°FUSDA safe minimum
Rest45 minbefore carving
Doneness dial Folio 017 of 30
USDA safe zone — 145°F and above 145°F 100 120 140 160 180 200 145°F USDA SAFE MINIMUM

USDA safe zone 145°F and above

Done is a temperature, not a time. Every figure on this page is a planning range; the green band is the only part that decides. For a pork butt in the smoker it opens at 145°F and a 45-minute rest.

SourceUSDA Food Safety & Inspection Service safe minimum internal temperaturesretrieved 2026-07

How this is worked out

  1. Anchor. Start from what USDA FSIS publishes for a pork butt in the smoker — its safe minimum internal temperature of 145°F, and the FSIS roasting timetable where one exists for this cut.
  2. Rate. Convert the anchor into a planning rate at 275°F: 60–75 min/lb, cross-checked against at least three independently published sources.
  3. Scale. Multiply that rate by your weight. A 8 lb piece lands at 8 hr – 10 hr; the range is widened to cover source disagreement rather than averaged into false precision.
  4. First check. The first thermometer reading is set at 85% of the low end of the range — early enough that an under-reading costs nothing and a late one cannot cost the meal.
  5. Gate. The time is only a plan. It is not done until a food thermometer reads 145°F in the thickest part, then rests about 45 minutes. Time never overrides temperature on this site.
  6. Round. Every printed figure is rounded to the nearest 5 minutes; precision beyond that would be invented.
plan_low    = weight_lb × 60 min/lb
plan_high   = weight_lb × 75 min/lb
first_check = plan_low × 0.85

DONE  ⟺  internal_temp ≥ 145°F  AND  rest ≥ 45 min
          (USDA FSIS — the gate, not the clock)

Full method and sources →

SOURCE·USDA FSIS safe minimum internal temperatures·safe minimum for this cut·REVIEWED JUL 2026

Full table

Time by weight at 275°F

Planning ranges for a fully thawed, fridge-temperature smoked pork butt. The right-hand column is when to take the first thermometer reading.

Timing ledger — 275°F smokerFolio 017 of 30DATA · JUL 2026
WeightEstimated time at 275°FCheck thermometer from
6 lb6 hr – 7 hr 30 min5 hr 5 min in
7 lb7 hr – 8 hr 45 min5 hr 55 min in
8 lb8 hr – 10 hr6 hr 50 min in
9 lb9 hr – 11 hr 15 min7 hr 40 min in
10 lb10 hr – 12 hr 30 min8 hr 30 min in
 Set 275°FPull at 145°F internal Rest 45 minEntries 5

Start checking the internal temperature well before the low end of the range — an early check costs nothing; a late one costs the meal. Done means 145°F on a food thermometer (see the pull-temperature note below).

SOURCE·USDA safe-temperature guidance·timing ranges derived, see method·REVIEWED JUL 2026

275°F vs the other temperatures

Same cut, every temperature this site publishes for it.

Temperature ledgerFolio 017 of 30DATA · JUL 2026
Oven tempTime for a 8 lb smoked pork buttPer pound
225°F12 hr – 14 hr 40 min90–110 min/lb
250°F10 hr – 12 hr75–90 min/lb
275°F (this page)8 hr – 10 hr60–75 min/lb
 Cut Smoked Pork ButtTemperatures 3Done at 145°F internal

SOURCE·USDA safe-temperature guidance·timing ranges derived, see method·REVIEWED JUL 2026

The gate

When it is actually done

145°F internal

The USDA FSIS safe minimum internal temperature for this cut is 145°F, followed by a rest of about 45 minutes. The clock estimates; the thermometer decides. Every time on this page is a planning range, not a doneness test.

Pull temperature vs safe temperature: Pulled pork is pulled at 195–205°F, not at the 145°F safe minimum — most pitmasters probe around 203°F and check that the blade bone wiggles free.

SOURCE·USDA FSIS safe minimum internal temperatures·smoked pork butt row of the FSIS chart·REVIEWED JUL 2026

The clock tells you when to start looking. The thermometer tells you when to stop.

What the ledger does not tell you

  • The most forgiving cut in barbecue — the fat and collagen cover a multitude of temperature swings. If you are learning to smoke, start here, not with brisket.
  • An 8 lb butt at 225°F is a 12–14 hour cook. Overnight cooks are normal; that is what leave-in probes with alarms are for.
  • Finished early is a non-problem: wrapped in towels in a dry cooler, a butt holds above 140°F for 4+ hours and arguably improves.
The second question

Answers people ask

How long does a pork butt in the smoker take at 275°F?

Plan on 60 to 75 minutes per pound at 275°F. A 8 lb example takes about 8 hr – 10 hr. It is done when the internal temperature reaches 145°F on a food thermometer, not when the clock runs out.

What internal temperature is a pork butt in the smoker done at?

145°F, measured with a food thermometer in the thickest part, then rested about 45 minutes. That is the USDA FSIS safe minimum. Pulled pork is pulled at 195–205°F, not at the 145°F safe minimum — most pitmasters probe around 203°F and check that the blade bone wiggles free.

Is 275°F a good temperature for a pork butt in the smoker?

It is one of 3 temperatures this site publishes for this cut (225°F, 250°F, 275°F). Lower runs longer and more forgiving; higher runs faster with more browning. 250°F is the most common choice.

SOURCE·USDA FSIS safe minimum internal temperatures·doneness figures quoted in these answers·REVIEWED JUL 2026

Where these numbers come from

Ranges are anchored to USDA FSIS published timetables where they exist, and derived from that anchor plus cross-checked published sources where they do not — widened to cover the disagreement between sources rather than split down the middle. The full reasoning is on the method page. If a figure here looks wrong, say so — corrections are prioritised.

SOURCE·USDA safe-temperature guidance·timing ranges derived, see method·REVIEWED JUL 2026

See all 10 sites in this family, with what each one answers

Published by

Amit Sharma

Auckland real-estate agent and marketer. Builds free, sourced data tools.